Download here: http://gg.gg/wd5vs
Hi Mike,
ARMING IN “EXIT” MODE EXIT is used when the user is away from the premises and wants the interior protected (the motion detectors ON). Close all protected doors and windows. Press the EXIT key. ARMING IN “STAY” MODE STAY is used when the user is inside the premises and wants protection around the perimeter. An extensive tutorial on programming the NX4, NX6, and NX8 Interlogix NetworX panels <Back Hi. My name is Jason with alarmsystemstore.com. In today’s video, I’m going to be doing the basic programming for the Interlogix NetworX panels. This video will apply to any of the network systems, the NX4, NX6, NX8. The GE Caddx Networx line of security systems offer many of the features of more complicated alarms, but at very reasonable prices. The 3 main panels are the GE NX-4, NX-6, and the NX-8. The smallest is the NX-4, with 8 on-board zones. The largest panel is the Caddx NX-8, with 8-zones on-board, expandable to 48. NX-208E Two-Wire Smoke Loop Expander Installation and Startup I-NX208E-IM Rev B July 2005 Product Summary The NX-208E is a microprocessor-controlled 2-wire smoke expander for the NetworX NX-6, NX-8, NX-8-CF, NX-8E and NX-8E-CF control panels. One NX-208E module can be added to the NX control panel with a maximum zone count of 8 zones.
Do you want to do a ’factory default’ on the NX-8 panel? If that is what
you want to do, click the following link for the manual. Go to page 8 and
follow the instructions for ’Loading Factory Defaults’ in the center of the
page.
NOTE: Doing this will clear the program, requiring you to program the entire
system from scratch. Please be absolutely certain this is what you want to
do before doing so.
If all you want is to change the Download Access Code, that is stored in
Location 20. Follow the instructions for changing that value alone.
Another significant code is the ’Go To Program’ code, found in location 42.
It’s a 4- or 6-digit code. This is the code you use to enter programming
mode.
To change any item, enter programming as follows:
Disarm the system.
Press [*]-[8].
Enter the current ’Go To Program’ code.
Press [0]-[#] to program functions of the NX-8 master control panel itself.
Enter the location number you wish to display/alter, followed by the [#]
key.
Enter the desired new data, followed by the [*] key.
After you press the [*] key the program will advance to the next segment.
Change it if needed and press [*] to scroll on. Torrent vray for maya mac os.Nx 8 Panel
For more detailed instructions, see page 9 of the manual I referenced above.
Regards,
Robert L Bass
>
Bass Home Electronics
The Online DIY Alarm Store
http://www.Bass-Home.com
4883 Fallcrest Circle
Sarasota, FL 34233
877-722-8900 Sales & Tech Support
941-925-9747 voice (Florida)
941-923-6238 fax
Rober..@home.com
>Caddx Nx 8 Installation Manual

’mtaylor’ <t1..@bellsouth.net> wrote in message
Card data recovery for mac. news:3a491003.14488445@news.lig.bellsouth.net..
Download here: http://gg.gg/wd5vs

https://diarynote.indered.space

コメント

お気に入り日記の更新

テーマ別日記一覧

まだテーマがありません

この日記について

日記内を検索